Getting Down To Basics with

Water Heater Maintenance Tips for Homeowners

All homeowners know the importance of a steady water supply. The water is used for a lot of things. The trait of water that is of great importance is the temperature it has. When the weather is hot, using cold water is not so bad. Warm water is important when it is cold. Because of this, you must have a water heater. The one thing that accounts for the most energy use in most houses is a water heater because of how much they are used. The only way to be able to have the water heater for long is to give it proper maintenance. There are many ways that you can be able to do this. Here, you can be able to read more on how to properly do maintenance of a water heater.

The first aspect to consider is that you should so an annual flush of the water tank once in a year. It is vital to flush the water heater’s tank. Flushing the tank will prevent any sediment buildup. If there is a high number of sediments then the energy that the water heater will need to heat the water will be very high. This will cause the energy bill to increase.

At this stage, you should take the time to have the water heater insulated. Doing this is what will extend the water heater’s life. One good insulating material that you should make use of is called insulating foam. This way the heat that is generated will be contained. The end result is that you will have a more efficient water heater. When insulating you should go as far as the water pipes.

The third maintenance tip for you to follow is that the air filters should be cleaned. Ideally the water should not contain any kind of debris. The only time that debris can get in the tank is if the air filter is not working okay. The water heater will therefore be easily damaged from the inside by the debris. Cleaning an air filter is best done by hand.

You should also know more about the state of the anode rods that are usually in the tank. If there are anode rods in the tank then the tank will no rust. If they have rusted too much you must remove them. If you do not do that then it is the water heater that will be rusting very quickly. It is in your best interest to always check on the TPR valve so that you know more about its condition.

Researched here: look at this website